8100 : Configuring Ratio Measurements (8104 Only)

Modified on Wed, 03 Mar 2021 at 08:22 AM

Note - Application note applies to firmware version 1.0.7 onwards.


The 8104 features a fully configurable ratio mode, allowing users to select the number of samples to take on each set of terminals and the settling time after switching.


To configure these settings from defaults (5 samples on each set of terminals, with 10 samples allowed for settling after switching), follow the instructions below : 


  1. Press the MENU key to enter the main menu.
  2. Navigate to RATIO CONFIGURATION and press the ENTER key or push the Digital Control.
  3. Select the desired menu item and configure as desired.



Press the BACK key to exit the menu and return to the measurement screen.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article