1000 Series : Low Current Protection Fuse

Modified on Fri, 17 Mar, 2023 at 1:33 PM

The 1000 Series is fitted with a protection fuse to protect both the UUT and the 1000 series in the event of a fault or externally applied current.

The user can replace this fuse by removing the 1000 Series from the case and replacing F4 (an ultra-rapid 1A, 20mm fuse)

A picture showing the location of F3 can be seen below :


The board does not need to be removed from the unit to replace the fuse.

Replacing the fuse will have no affect upon the calibration of the unit

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article